English | ¼òÌåÖÐÎÄ
HOME JAJ PRODUCTS ABOUT JAJ SOLUTIONS NEWS CENTER TECHNICAL SUPPORT

JAJ BEARINGS

One of the advanced bearing
industry solution suppliers
all over the world
Homepage / JAJ Products / Self-aligning ball bearing

Self-aligning ball bearing

Self-aligning ball bearing was developed by JAJ. It has two columns balls and raceway in the outer surface. So the bearing can be automatically adjusted, and can withstand the angle difference between axis and bearing base. In addition,   the self-aligning ball bearing friction is the lowest in all of the rolling bearings; even in the high speed condition, it still only has a smaller temperature rise.
The self-aligning ball bearing¡¯s basic design can be a cylinder or cone hole.   Bearing with cone hole can be directly installed on the shaft or set or withdrawed.
JAJ self-aligning ball bearing can use a variety of design, including:

Seal, Contact seals on both sides of the belt

Open bearing with extended inner ring

Related Products

> Needle rolling thrust bearing
> Tapered roller bearing
> Cylindrical roller bearing
> Trust ball bearing
> Angular contact ball bearing
> Deep groove ball bearing

JAJ PRODUCTS

Deep groove ball bearing
Angular contact ball bearing
Self-aligning ball bearing
Trust ball bearing
Cylindrical roller bearing

ABOUT JAJ

JAJ history
JAJ promise
Caring environment
Contact JAJ

SOLUTIONS

Aerospace
Agriculture
Car and light truck
Compressor
Motor

TECHNICAL SUPPORT

Dimension, Tolerance, Clearance
Misalignment
Holder
Technical specification
Axial preload
ALL RIGHTS RESERVED | TERMS AND CONDITIONS | COOKIE
© 2014-2020 JAJ Bearings Ltd. All Rights Reserved.